Thanks you for your reply, and I have installed a complete version of Office 2013, not the Click-to-Run installation.
However, eaDocX does not appear to work 🙁
I can open an existing Word document (in Word 2007 format) and as usual eaDocX identifies no profile and request one to be created. This I do (I have tried both the Full Details profile and generating a profile from the model), and all is fine
I add sections and all features work perfectly as expected 🙂
I perform a full generation and the document is generated and saved correctly 🙂
After closing eaDocX and restarting and re-opening the document just generated, it appears to eaDocX that there is no profile and no sections 🙁 🙁 possibly implying that the profile / sections were not saved after document generation.
The dialog for the profile selection is displayed
This happens every time, I have tried saving in Word 2003 format, to no avail, I have tried different profiles, same result. I have tried creating a brand new document in eaDocX, again same result.
I attach the Word document that has been generated from eaDocX using Office 2014 and upon re-opening appears to have no profile
The only installation difference between my previous version of Office and the new Office 2014 installation, is that Office 2014 has been installed as 64bit, whereas my previous version was 32bit.
That cannot be the cause of the problem, or can it?
Any advice more than appreciated.
Best regards
Phil
